No Detail Found!

Comparative Analysis of Pressure Regions of Gaseous Benzene using Ground Activated Carbon Sorbents under Ambient Conditions.

Author(s)
Azmatullah Khan Department of Civil Engineering, Balochistan University of Information Technology, Engineering and Management Sciences, Quetta, Pakistan
Saeedullah Jan Mandokhail Department of Civil Engineering, Balochistan University of Information Technology, Engineering and Management Sciences, Quetta, Pakistan
Naik Mohammad Department of Civil Engineering, Balochistan University of Information Technology, Engineering and Management Sciences, Quetta, Pakistan
Zafar Baloch Department of Civil Engineering, Balochistan University of Information Technology, Engineering and Management Sciences, Quetta, Pakistan
Mohammad Siddique Department of Chemical Engineering, Faculty of Engineering and Architecture, Balochistan University of Information Technology, Engineering and Management Sciences, Quetta, Pakistan
Muhammad Akram Department of Computer Engineering, Faculty of Information and Communication Technology, Balochistan University of Information Technology, Engineering and Management Sciences, Quetta, Pakistan
Abstract
The effective removal of atmospheric hazardous pollutants using activated carbon for the real-world application is a crucial and reliable process. Therefore, the performance comparison of ground activated carbon BPL 4×6 (ACb212) based on varied outlet pressure of benzene vapour were analyzed in ambient condition (room temperature and pressure). The maximum adsorption capacity was found ~110 mg. g-1) for all pressure regions. However, the competition showed maximum capacity for higher pressure region i.e., 50.5 mg. g-1, minimum capacity at lower pressure region 7.96 mg. g-1, and moderate for moderate outlet pressure 20.6 mg. g-1. On the other hand, the partition coefficient (PC) behaved inversely to the sorption capacity i.e., high PC (397 mol.kg-1. Pa-1) at the low outlet and low PC (1.47 mol.kg-1. Pa-1) at high outlet benzene partial pressure regions. The adsorption capacity on ACb212 followed the classical Langmuir isotherm of Type-1 at low and high-pressure outlet pressure regions, while a retrograde behaviour isotherm (Type-1) was observed for lowest benzene outlet partial pressure region. Furthermore, the linearized Langmuir isotherm analysis also confirmed the existence of two or more sorption sites for gaseous benzene.
Publication Details
Page(s) 160-167
DOI DOI not available
Published Journal: Journal of Applied and Emerging Sciences , Volume: 8, Issue: 2, Year: 2018

Request the full text from PASTIC

References
Ÿ AhmedE,DeepA,KwonEE,BrownRJ,KimKH, 2016.Performance comparison of MOF and other sorbent materials in removing key odorants emitted from pigpen slurry,Scientific Reports 6 31283 -
Ÿ AlghamdiMA,KhoderM,AbdelmaksoudAS,HarrisonRM,HusseinT,LihavainenH,Al-JeelaniH,Goknil M.H,ShabbajII,AlmehmadiFM,HyvärinenAP,HämeriK., 2014.Seasonal and diurnal variations of BTEX and their potential for ozone formation in the urban background atmosphere of the coastal city Jeddah, Saudi Arabia,Atmosphere & Health 7 467 -480
Ÿ KimKH,NguyenHT, 2007.Effects of injection volume change on gas chromatographic sensitivity determined with two contrasting calibration approaches for volatile organic compounds,Journal of Separation Science 30 367 -374
Ÿ LimTT,JinY,NiJQ,HeberAJ, 2012.Field evaluation of biofilters in reducing aerial pollutant emissions from a commercial pig finishing building,Biosystems engineering 112 (3) 192 -201
Ÿ NiJQ., 2015.Research and demonstration to improve air quality for the US animal feeding operations in the 21st century-A critical review,Environmental Pollution 200 105 -119
Ÿ RamosME,BonelliPR,CukiermanAL,CarrottMR,CarrottP., 2010.Adsorption of volatile organic compounds onto activated carbon cloths derived from a novel regenerated cellulosic precursor,Journal of Hazardous Materials 177 175 -182
Ÿ VellingiriK,SzulejkoJE,KumarP,KwonEE,KimKH,DeepA,BoukhvalovDW,BrownRJC, 2016.Metal organic frameworks as sorption media for volatile and semi-volatile organic compounds at ambient conditions,Scientific Reports 6 27813 -
Ÿ ZaitanH,BianchiD,AchakO,ChafikT., 2008.A comparative study of the adsorption and desorption of oxylene onto bentonite clay and alumina,Journal of Hazardous Materials 153 852 -859
Khan A, Szulejko JE, Samaddar P, Kim KH, Liu B, Maitlo HA, Yang X, Ok YS. (2018). The potential of biochar as sorptive media for removal of hazardous benzene in air. Chemical Engineering Journal 1:1-14.
Khan A, Szulejko JE, Kim KH, Sammadar P, Lee SS, Yang X, Ok YS. (2019). A comparison of figure of merit (FOM) for various materials in adsorptive removal of benzene under ambient temperature and pressure. Environmental research 168: 96-108.
Katsaros F, Steriotis TA, Stefanopoulos K, Kanellopoulos N, Mitropoulos AC, Meissner M, Hoser A. (2000). Neutron diffraction study of adsorbed CO2 on a carbon membrane. Physica B: Condensed Matter 276: 901-902.
Choma J, Osuchowski L, Dziura A, Marszewski M, Jaroniec M. (2015). Benzene and methane adsorption on ultrahigh surface area carbons prepared from sulphonated styrene divinylbenzene resin by KOH activation. Adsorption Science & Technology 33(6-8): 587-594.
Chen WH, Chen ZB, Yuan CS, Hung CH, Ning SK. (2016). Investigating the differences between receptor and dispersion modeling for concentration prediction and health risk assessment of volatile organic compounds from petrochemical industrial complexes. Journal of Environmental Management 166: 440-449
Caselli M, de Gennaro G, Marzocca A, Trizio L, Tutino M. (2010). Assessment of the impact of the vehicular traffic on BTEX concentration in ring roads in urban areas of Bari (Italy). Chemosphere 81(3): 306-311
Carlsen L, Bruggemann R, Kenessov B. (2018). Use of partial order in environmental pollution studies demonstrated by urban BTEX air pollution in 20 major cities worldwide. Science of The Total Environment 610:234-243.
0

Citations

0

Downloads

127

Views