No Detail Found!

Strength Behavoir Evaluation of Cement Mortar using Waste Fly Ash and Marble Dust.

Author(s)
Syed Zafar Department of Civil Engineering, Balochistan University of Information Technology, Engineering and Management Sciences, Quetta, Pakistan
Ahmed Bilal Department of Civil Engineering, Balochistan University of Information Technology, Engineering and Management Sciences, Quetta, Pakistan
Muhammad Ayoub Department of Civil Engineering, Balochistan University of Information Technology, Engineering and Management Sciences, Quetta, Pakistan
Syed Nasir Department of Civil Engineering, Balochistan University of Information Technology, Engineering and Management Sciences, Quetta, Pakistan
Anwaar Hazoor Department of Civil Engineering, Balochistan University of Information Technology, Engineering and Management Sciences, Quetta, Pakistan
Ali Nawaz Department of Mechanical Engineering, Balochistan University of Information Technology, Engineering & Management Sciences (BUITEMS), Quetta, Pakistan
Aamir Mehmood Department of Civil Engineering, Balochistan University of Information Technology, Engineering and Management Sciences, Quetta, Pakistan
Ehsanullah Kakar Department of Civil Engineering, Balochistan University of Information Technology, Engineering and Management Sciences, Quetta, Pakistan
Abstract
Pakistan being one of the most urbanized countries of the region having a large number of industries which have been known to produce large quantities of byproducts and wastes. For economic and environmental aspect the industrial waste reuse is appreciable because environmental contamination is the major issue associated with rapid increase in the byproduct and waste generated in the forms of fly ash and marble dust waste due to industrial activities. This study examines the mechanical properties of fresh and hardened cement mortar by using fly ash as partial replacement of cement and waste marble dust as partial replacement for fine aggregate in cement mortar at various percentages (0%, 5%, 10%, 15% and 20% by weight of the cement and fine aggregate) with water. An experimental investigation for the measurement of consistency, initial setting time and final setting time of cement with fly ash replacement were determined by using the Vicat apparatus. Consistency of cement mortar (Workability) with fly ash and waste marble dust replacement was determined by using flow table test. Cubes of the samples with fly ash and waste marble dust replacement as cement and fine aggregate were used to determine the compressive strength of hardened cement mortar. The test results showed that addition of fly ash and waste marble dust into cement mortar mixture significantly increased its compressive strength, initial setting time, final setting time and consistency of cement mortar, while consistency of cement was decreased as compared to conventional cement mortar. This study ensures that reusing of fly ash and waste marble dust as substitutes in cement mortar gives a good approach to solve industrial waste disposal problems.
Publication Details
Page(s) 145-150
DOI DOI not available
Published Journal: Journal of Applied and Emerging Sciences , Volume: 7, Issue: 2, Year: 2017

Request the full text from PASTIC

References
.ASTM C109/C109M-16a., -
Ÿ Baboo, 2014.Effect of fly ash on mortar mixes with quarry dust as fine aggregate,Advances in materials Science and Engineering -
Ÿ Nitisha, 2015.Use of Waste Marble Powder as Partial Replacement in Cement Sand Mix,International Journal of Engineering Research & Technology (IJERT) 4 501 -504
Ÿ Syed Zafar, 2017.Paper presented at the Striving Towards Resilient Built Environment, -
ASTM International. (2014). Standard Specification for Flow Table for Use in Tests of Hydraulic Cement ASTM C230/C230M-14.
ASTM International. (2016a). Standard Test Method for Amount of Water Required for Normal Consistency of Hydraulic Cement Paste ASTM C187-16.
ASTM International. (2016b). Standard Test Method for Compressive Strength of Hydraulic Cement Mortars (Using 2-in. or [50-mm] Cube Specimens) ASTM C109/C109M-16a
0

Citations

0

Downloads

49

Views