No Detail Found!

Effects of carburizing process variables on mechanical and chemical properties of carburized mild steel.

Author(s)
A. Oyetunji Dept of Metallurgical and Materials Engineering The Federal University of Technology, Akure Ondo State, Nigeria
S. O. Adeosun Dept of Metallurgical and Materials Engineering University of Lagos, Akoka Lagos, Nigeria
Abstract
This work evaluates the suitability of using palm kernel shell, animal bone (mammalian bones from cattle) and sea shell (oyster shell) materials as carburizers for case hardening of 0.078%C mild steel. The mild steel sample used in this study sourced from universal steel company, Ikeja Lagos Nigeria was cut into suitable sizes using hacksaw machine for tensile and hardness tests. The carburizing media used were milled into fine powder while Barium trioxo (iv) carbonate (VI) (BaCO3) was used as an energizer in the carburizing process. Three rectangular stainless steel plate boxes were fabricated to accommodate each of the steel samples and carburized. A calculated amount of each carburizer was weighed into each of the stainless steel boxes and 20 wt % of BaC03 was mixed with each of them. Mild steel samples were covered completely in each of the boxes with the mixture of the carburizer and energizer placed in the furnace chamber. The carburizing temperatures varied between 700 - 1100°C while the holding time varied between 1-5 hrs. The boxes and its contents were allowed to cool down to room temperature in the furnace after carburization. All samples were heated to 850°C after been soaked for 30 minutes at this temperature and oil quenched. This was to increase the hardness of the case. Fifteen (15) of these samples were further tempered at 350°C for 2hrs to relieve the stress built up during quenching. Hardness test, tensile strength tests and chemical analysis were carried out on the samples. It was observed that the hardness values of the untempered samples are superior to the tempered ones at carburizing temperatures of 700°C, 800°C and 900°C. On the other hand, the tensile strengths of the tempered samples are higher relative to the untempered samples at carburizing temperatures of 700oC, 1000oC and 1100oC. The results of the carbon analysis show that palm kernel shell and animal bone are potentially suitable to be used as a carburizing media than the sea shell at high temperatures (above 1000°C) with holding time above 1 hr.
Publication Details
Page(s) 319-324
DOI DOI not available
Published Journal: Journal of Basic and Applied Sciences, Volume: 8, Issue: 2, Year: 2012

Request the full text from PASTIC

0

Citations

0

Downloads

64

Views